PID Control Mode

Advanced Multi-Functional DO Control

A Stainless Vessel and Frame

One Highly Efficient Exhaust Air Codenser  and One Windowed Vessel

Freely Defined Parameters on Sterilization

User-defined Applications for Peristalsis Pumps

Easy Adjustment by Software

Computer Recordable Output Signals With Bilateral Control

Ring Type Blowing Pipes

One Windowed Port for Feeding Material

Four 25mm Upper Brim Ports for Electrodes

Six 25mm Lower Brim Ports for Electrodes

Three 19mm Ports for Feeding Material on the Headplate

Two Ports for Foam Probes (Foam /Hi-Foam))

One Sterilizable Diaphragm Pressure Sensor

One Aseptic Water Maker and Dua Seal

One Basal Sterilizable Harvest Valve Ranked Within Sanitary Industry

One Side Sterilizable Valve for Sampling

One 40mm Port for Inoculation

Vessel Volume: 200~250 Liter( With Internal Vessel SS316L)

Polish on the Vessel: With 240grit in Internality, While 240grit in Externality

Temperature-Control Range: Cooling Water From 5℃ to 80℃ (+/-0.1)

Stirring Speed: 25 to 450rpm (Measured from the Top or the Bottom)

Air Sparger: 5 to 350 slpm(Mass Flow)

pH Range: 2-12.00 pH

DO Range: 0 –100%( Related to Such Control as Stirring Speed, Air Sparge, and Pressure in Vessel)

Air Filter: 0.01μm Inlet and Exhaust( Sterilization-repeatable)

Foam Sensor: Conductivity Type (Foam/Hi-Foam)

Vessel Pressure: 0-3.5kg/cm² (Within SS316L Where Diaphragm Features)

Valves: Sanitary-Industrial Pneumatic Diaphragm Valves

Signal Outputs: 4-20mA or RS232 Compatible

Peristalsis Pumps: 4 Free-set Functions for Pumping Acid, Pumping Alkaline, Foaming or Feeding Material

Powering: 220Vac/50-60Hz., 3-Phase

Air Source: 2~3Kg/cm² (for the Fermentor) 5~6Kg/cm² (For Pneumatic Valves)

Water Source: 1.5~2.5Kg/cm²

Steam Source: 2.5~4Kg/cm²

Auto-Lifting Headplate: Mechanical Transmission by the Motor